|
The hold
down bracket and clips are not shipped pre-installed on the
unit because the ends of the wing nuts would tear at the
shipping container, possibly allowing for damage to the
unit. This item is easily installed and only requires
installation one time. These directions are provided to
assist with this installation.
|
Step 1.
Gently tip the unit on the side as shown. This will
not damage the unit as long as it is done gently.
|
|
|
Step 2.
Remove the two rubber feet by gently
twisting and pulling the feet. Remove the wing nuts
and the hold down clips from the bracket with the
two holes (this makes installation easier). Hold the
bracket in place so that the holes are lined up with
the holes on the base and with the studs toward the
end of the unit. While holding the bracket in place,
replace the feet into the holes (a gentle twist
maybe necessary to seat the feet).
|
|
|
Step 3.
Gently tip the unit back to the
operating position. Install the hold down clips with
the wing nuts. The hold down bracket is designed so
that it can move slightly, adjust the bracket so it
is even with the end of the unit and is centered
from side to side of the unit. The printed material
can now be placed on the pad and the hold down hooks
adjusted to hold pressure on the material to keep it
from sliding. Caution – Do not use excessive
pressure to hold material in place as it could cause
the material to not lay completely flat. Use only
enough pressure to hold the material in place. |
|
|
